Hi all, I have an Intellitouch system running firmware 1.16. I recently installed an Intelliflo VSF and the installer (a Pentair certified) connected it to J7 on the Intellitouch panel. When we brought up the equipment screen, there was nothing on the left hand side, while the right hand side lists solar, 2-Sp pump, filter delay, manual heat, degrees c/f. He called the Pentair guy and was told my Intellitouch firmware was too old to control an Intelliflo variable speed pump and I need to replace the motherboard. Is this correct?
For the moment, I am using the Intellitouch to turn the pump power on/off and have the pump set to Manual mode. It works for pool use but requires me to go the pump and change the program to a higher speed for spa use. Not awful but a pain in the rear..
For the moment, I am using the Intellitouch to turn the pump power on/off and have the pump set to Manual mode. It works for pool use but requires me to go the pump and change the program to a higher speed for spa use. Not awful but a pain in the rear..
Last edited by a moderator: