Intelliflo pump won't go past 28gpm?

[mihzyd777]

I checked the pump and limited are set to 3450 rpm and 80gpm, however when I go into intellicenter app and put it at anything higher than 30gpm it will not go as you can see on the screen shot. When it starts priming set to 3450 and it goes that high without issue.

What could be causing this?

Thanks!

 

[JamesW]

Probably hitting the pressure limits.

Put the system in service mode and then check the settings from the pump control panel to see what the max psi is set to and what the pump system pressure is while running.

What is the filter pressure?

You probably need to clean the filter.

 

[mihzyd777]

I'll check in the morning, but it was working fine up until the other day and then bam the next day it started doing it.