Inground vinyl liner install

[Rakuz66]

I went around my “Under Construction” vinyl liner install today with my 4ft level, I found 1 wall panel where it leaned in about a 1/2 inch,,, is that too much? Any type of hazard ?? They will be poring the concrete to secure the braces on Monday, thx

 

[kimkats]

Can you move it at all by pushing on it? This is something I would make sure to be there when they show up on Monday. I would also get an email or text into the installer asap to give them a heads up.

 

[rhumbaclave]

Do you have turnbuckle supports? If so you can adjust the top which is the most important part.

 

[Rakuz66]

No turnbuckle supports, it’s a polymer wall pool with brace supports. I basically fixed the lean myself. However in doing so I seen this! These braces are supposed to catch the end of one panel and the beginning of another. Obviously, this is only catching 1 panel, and there’s a shim in between the panels on a curved section. There are 3 braces in a row like this. It’s in the shallow end of a kidney pool. Do I shut this down now? Or is this normal?

 

[kimkats]

Do you have access with the installation manual? What does it say?

 

[Rakuz66]

I noticed this tiny stress fracture in the back of my polymer pool panel today,, is this a big problem? What type of epoxy can I use on polymer panels? thanks

 

[ajw22]

What model pool are we discussing?

Have you asked the pool manufacturer?

I don’t think epoxy or any glue will structurally strengthen a crack in a panel.