iAqualink upgrade question

[Steve Bennett]

Hi All,
I'm looking to upgrade our Aqualink RS8 to the iAqualink setup. The indoor control panel is dead so I can't use the diagnostics to get any info. The pool-side PCB info is:
PCB: 6474-G
Chip: JI6520 Rev I
Photo of PCB is attached.

I'm pretty sure I need to get the iAquaLink 3.0 Upgrade Kit (IQ30-RS) but wanted to double-check with the forum to see if that's correct and also if I'll need anything in addition to that.

Thanks!

 

[HermanTX]

The IQ30-RS includes the new PCB which should be rev. T2 or later. It also will include the 3.0 Antenna.
You will install the new board (PCB) and connect all the same connections to the AUX sockets, temperature sensors, etc.
It is a fairly simple process.
Then you will install the antenna and connect the 4 wires to the RED connector on the PCB.
There is a set up process that you must go through to register and get it to link up to the server.

 

[HermanTX]

See the attached which gives more info

Jandy Aqualink RS - Further Reading

www.troublefreepool.com

Show a picture of the AquaLink box with the front panel removed to show the relays and circuit breakers.

 

[Steve Bennett]

The IQ30-RS includes the new PCB which should be rev. T2 or later. It also will include the 3.0 Antenna.
You will install the new board (PCB) and connect all the same connections to the AUX sockets, temperature sensors, etc.
It is a fairly simple process.
Then you will install the antenna and connect the 4 wires to the RED connector on the PCB.
There is a set up process that you must go through to register and get it to link up to the server.

Thanks for the info, very much appreciated.