My solar temp sensor is broken and it will be a while before it's fixed, since it's the buried wire in the yard that is bad, so I have programed my JVA to run off the extra aux switch so I can run the solar roof heater based on time of day. However, I noticed that the Jandy system does not automatically pause the pump when controlling the JVA from aux like it does when switch between spa and pool modes. Is there any way to fix this without complex program schedules to shut down pump, move valve, restart pump?
iAqualink Pump Does Not Stop for JVA controlled by Aux
- Thread starter ams123
- Start date
- May 3, 2014
- 62,672
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
- Jun 7, 2017
- 9,966
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
I am not sure if you can do what you want automatically. I think you will need to manually enable your solar until the temp probe is fixed. You could try a OneTouch but I don't think that is going to shut the pump down it will just change the speed to something else. And only do it once not slow it and speed it up like you probably need it to do.