I have a Jandy iAqualink setup with a waterfall and deck jets. The system believes the deck jet valve is open, but it's actually not. This happened after a power outage. Is there any way to reset its status? Currently, the reverse of whatever is set is actually what the setting does.
iAqualink deck jets stuck "on" but not actually running
- Thread starter OKLagoon
- Start date
- Jul 21, 2013
- 65,368
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
- Jul 21, 2013
- 65,368
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
There is a toggle switch on the side of the actuator that has 3 positions - ON1-OFF-ON2.
If the Aqualink thinks the valve is open then flip the togged switch to the other side and the valve will turn and be open. The actuator should then agree with the Aqualink.
If the Aqualink thinks the valve is open then flip the togged switch to the other side and the valve will turn and be open. The actuator should then agree with the Aqualink.
