Hi TPS members. I have a Hybrid Pool (fibreglass vertical sides from the ledge to the coping and gunite bottom and sloping sides). I have a small tear in the fibreglass that I intend to get repaired. I would like to drain the pool just below the ledge. Should I have a concern about the fibreglass sides popping out due to ground water? I wouldn't expect so because they are only around the top 4 feet of the pool. Any advice would be appreciated...thanks
Hybrid Pool. Repairing the fibreglass sides
- Thread starter jse9901
- Start date
- Jul 21, 2013
- 53,111
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
You think your groundwater level could be up to the fiberglass panels?
www.troublefreepool.com
You think your groundwater level could be up to the fiberglass panels?
Hybrid Pools - Further Reading
www.troublefreepool.com
Thanks for the suggestion. I doubt that the ground water would be up that high. The fibreglass panels are from deck level - then down 4 feet. I would expect my ground water to be significantly lower than that.Welcome to TFP.
You think your groundwater level could be up to the fiberglass panels?
Hybrid Pools - Further Reading