Hi.
I have a new pool. For some reason my AquaCal SQ166 is not coming up when using the Automation system. No matter if I press Pool or Spa Heat it won't come up. On the HeatPump display I can see the display saying "Under Remote Control". Not sure if the wiring is correct. I did open the Aqualink and I saw that the installer used pin 1 and 2 on the green terminal bar (Low Voltage Heater) to connect the AquaCal. Not sure if he used the Ext Controller Section on the AquaCal (Pin Z and Y). I haven't open the AquaCal panel yet.
My question is that the best method or using the RS485 terminal bar is better on the automation side and using Port B on AquaCal. I think that if using the RS485 the controller will be able to work with Heater and Chiller but not if using the Green Terminal Pin 1, 2.
Anyways ... any idea why it may not be starting when using the automation system. Again a new pool. PB already know about it and I think a Warranty company is coming over to check but I think it is just a wiring issue (Manual Operation works fine on the AquaCal).
TIA,
embeleco
I have a new pool. For some reason my AquaCal SQ166 is not coming up when using the Automation system. No matter if I press Pool or Spa Heat it won't come up. On the HeatPump display I can see the display saying "Under Remote Control". Not sure if the wiring is correct. I did open the Aqualink and I saw that the installer used pin 1 and 2 on the green terminal bar (Low Voltage Heater) to connect the AquaCal. Not sure if he used the Ext Controller Section on the AquaCal (Pin Z and Y). I haven't open the AquaCal panel yet.
My question is that the best method or using the RS485 terminal bar is better on the automation side and using Port B on AquaCal. I think that if using the RS485 the controller will be able to work with Heater and Chiller but not if using the Green Terminal Pin 1, 2.
Anyways ... any idea why it may not be starting when using the automation system. Again a new pool. PB already know about it and I think a Warranty company is coming over to check but I think it is just a wiring issue (Manual Operation works fine on the AquaCal).
TIA,
embeleco