Ignore the pool equipment in my signature that is our other home.
Pool pump on a dedicated GFCI
Jandy controls
H400FDN heater and it is fed from the same circuit as the pump (relay 1 in jandy control)
Pump runs all day with no issue (1hp generic) if I move the system to spa mode and turn the heater on it fires up, but the breaker trips within 30 mins and then will just keep tripping (breaker feels warm)
I swapped out the igniter and removed and cleaned the flame sensor.
Thoughts on what to check next?
Pool pump on a dedicated GFCI
Jandy controls
H400FDN heater and it is fed from the same circuit as the pump (relay 1 in jandy control)
Pump runs all day with no issue (1hp generic) if I move the system to spa mode and turn the heater on it fires up, but the breaker trips within 30 mins and then will just keep tripping (breaker feels warm)
I swapped out the igniter and removed and cleaned the flame sensor.
Thoughts on what to check next?
Last edited: