My H400fdn Hayward Heater will not turn on with the Omnilogic remote reliably. If I take the heater out of bypass mode I can run it manually without issues. I am using the 2 wire remote from the OmniLogic control (lv2) to the heater wiring block. I checked the wires for continuity, reran the configuration, met minimum GPM, and power cycled each piece. I manually ran the heater today for a bit and turned it off, I called Hayward and as soon as I walked to the heater and put it in remote mode it worked. I felt like an idiot for wasting his time and hung up. I tested different modes and it all worked. I tried to run it again tonight and it would not work. The spinning circle next to the power toggle (indicates device is running) was Greyed out and the power toggle switch on the screen would keep turning off. I'm thinking there may be conflicting programming with my configuration. Is there a trick not in the manual? I'm going to try on Monday to call them again but I really want to figure it out myself.