So my heater won't light. Typical IF code. Pulled the orifice tube and cleaned orifices. They were spotless clean.
Pulled each burner tube and inspected. Baffles have some corrosion but flame holes look great. Removed loose scale.
Pulled ignitor and tested, gets red hot.
Pulled flame sensor and cleaned.
Gas valve is working because I can feel it move through the cycle. Pulled 18v with cheap meter.
Increased gas pressure slightly, no help.
Only thing left that I Know of is the control board.
Any advice??
Pulled each burner tube and inspected. Baffles have some corrosion but flame holes look great. Removed loose scale.
Pulled ignitor and tested, gets red hot.
Pulled flame sensor and cleaned.
Gas valve is working because I can feel it move through the cycle. Pulled 18v with cheap meter.
Increased gas pressure slightly, no help.
Only thing left that I Know of is the control board.
Any advice??