I am worried that I may not have blown all of the water out of my pipes. Picture attached. I drained the filter connected air compressor closed the two valves after the filter which gave me pressure and started with the skimmer workEd my way around the pool plugging the returns and then switched the valve connected to the pump to the main drain waited a couple minutes after bubbles came up turned valve back to skimmer side and turned compressor off. My concern is at some point should I have opened the 2 return valves after the filter and blown those out? If so in what order do I do that. I hope this was clear enough and thank you for any advice you can share...
Flushing Lines for Winter
- Thread starter Bither
- Start date
- Jul 21, 2013
- 53,075
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
It is hard following exactly what you did step by step. Lets start with where did you connect the air to and what type of blower did you use?
This may help you review what you did or did not do....
www.troublefreepool.com
It is hard following exactly what you did step by step. Lets start with where did you connect the air to and what type of blower did you use?
This may help you review what you did or did not do....
Closing Pool for Winter - Further Reading
www.troublefreepool.com