Hello,
According to the main thread (Jandy Aqualink RS - Further Reading) it should only be a matter of reading the Aqualink All-Button Panel. Unfortunately, all mine says after cycling through some basic info is LOW BATTERY despite getting a brand new one just now.
I took pictures of the PCB. Is there a way to tell just looking at it?
Would it be the "F" in PCB#6474-F?
Regarding iq20-a vs iq20-rs, I don't see any way I could just plug a chip on my PCB (as seen in this youtube clip), so I am guessing I need to go with iq20-RS.
IQ20-RS comes with the full PCB board replacement, is that correct?
Thank you!
Alex
According to the main thread (Jandy Aqualink RS - Further Reading) it should only be a matter of reading the Aqualink All-Button Panel. Unfortunately, all mine says after cycling through some basic info is LOW BATTERY despite getting a brand new one just now.
I took pictures of the PCB. Is there a way to tell just looking at it?
Would it be the "F" in PCB#6474-F?
Regarding iq20-a vs iq20-rs, I don't see any way I could just plug a chip on my PCB (as seen in this youtube clip), so I am guessing I need to go with iq20-RS.
IQ20-RS comes with the full PCB board replacement, is that correct?
Thank you!
Alex
Attachments
Last edited: