Good morning,
Did some basic troubleshooting; Power Cycle; Cable Check on pump, Cable Check on Panel, remove and clean terminals but the error persists. I can turn the pump on manually via the top panel and set timers, but that obviously doesn't help the automation/variable speed/timers side.
i saw a previos issue from a few years back where the top drive on the pump had to be replaced - just wondering if anyone else has some info/help?
This is the 5th issue with Hayward equipment. I've had 3 LED Colorlogic lights replaced (the 3 new ones have all failed outside warranty), Heater failure (obstructed blower tube) and now this pump. Not sure impressed with Hayward so far...
Did some basic troubleshooting; Power Cycle; Cable Check on pump, Cable Check on Panel, remove and clean terminals but the error persists. I can turn the pump on manually via the top panel and set timers, but that obviously doesn't help the automation/variable speed/timers side.
i saw a previos issue from a few years back where the top drive on the pump had to be replaced - just wondering if anyone else has some info/help?
This is the 5th issue with Hayward equipment. I've had 3 LED Colorlogic lights replaced (the 3 new ones have all failed outside warranty), Heater failure (obstructed blower tube) and now this pump. Not sure impressed with Hayward so far...
Last edited: