Hi All,
Just had my pool renovated and all my equipment redone with an EasyTouch 8 pool and spa panel (do not have a spa though) with screenlogic. My current equipment is an intelliflo VS, raypak heatpump and hayward sand filter. I have no electronic valves and only a pool. I currently have the Pump scheduled to run from 9am to 10pm at 1750 rpm and the heater set a low temperature during that time. I would like to setup a program that is sort of a manual override that I could press that would allow the system to run on a slightly higher speed with the heater set to a higher point if say my wife wanted to swim the next day and i wanted it to be a little warmer and run overnight. I'm racking my brain around how to do this as if i'm understanding correctly the schedule that is programed for pool will always take over the pump. Can someone help me figure out how to program a sort of "heat boost" program to run for like 12 hours or something everytime i press a button?
Just had my pool renovated and all my equipment redone with an EasyTouch 8 pool and spa panel (do not have a spa though) with screenlogic. My current equipment is an intelliflo VS, raypak heatpump and hayward sand filter. I have no electronic valves and only a pool. I currently have the Pump scheduled to run from 9am to 10pm at 1750 rpm and the heater set a low temperature during that time. I would like to setup a program that is sort of a manual override that I could press that would allow the system to run on a slightly higher speed with the heater set to a higher point if say my wife wanted to swim the next day and i wanted it to be a little warmer and run overnight. I'm racking my brain around how to do this as if i'm understanding correctly the schedule that is programed for pool will always take over the pump. Can someone help me figure out how to program a sort of "heat boost" program to run for like 12 hours or something everytime i press a button?