Hey y’all. Hope everybody is have a great 4th. My pool cleaner wall adapter broke so I’m having to manually pump the pool until it comes in. I have a Pentair easy touch and am trying to adjust the pump speed. Problem is, it won’t save it. I can adjust the rpm and circuit name but not the speed. Every time I back out and go back in, it reverts back to speed 1. Any advice? Side note, when I up the rpms, I can’t hear a change in motor speed.
Easy touch pump speed adjustment
- Thread starter Darrellelliott
- Start date
- Jul 21, 2013
- 53,352
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
- May 3, 2014
- 58,721
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Darrell - I assume you are making the adjustments at the ET panel and you do not have Screenlogic.
Select Pump #1, Speeds, select the Circuit you want, then set the Speed, back out via the menu. Then you need to turn on that Circuit by either scheduling it or using an Egg Timer.
Select Pump #1, Speeds, select the Circuit you want, then set the Speed, back out via the menu. Then you need to turn on that Circuit by either scheduling it or using an Egg Timer.
blakeusa
In The Industry
Should go into
Settings
Intelliflo
Pump Speed ..
Move down to speed and increase
It should save when you enter and go back to main screen.
You could also program a new circuit for Vac and have it ramp the pump to say 3000 RPM
Settings
Intelliflo
Pump Speed ..
Move down to speed and increase
It should save when you enter and go back to main screen.
You could also program a new circuit for Vac and have it ramp the pump to say 3000 RPM