Easy touch/Intelliflo3 VSF Schedule Setup

[soccerballbmw]

I usually have my pump running from 8am to 10:30pm and have not changed the pump settings from the builder. I'm going to move to 24/7, because i like to hear the fountain going and not have stagnant water, even if its at a very low speed. When looking through the easy touch panel (i do not have the app) the set up shows as:
Pump type: VSF
RPM: 2400
That's all that looks to be set up for the pool circuit. Leaving me with a 2 part question:

1) How do I schedule various speeds at various times? I've adjusted the schedule plenty of times, but i don't see an option of programming a time associated with a speed.

2) How do I determine those speeds and times from the first question?

Thank you in advance!

 

[mknauss]

Back up in the menu and select Schedule. First one should be Pool. Change to 8 am to 8 am.

Continuously running a fountain will tend to push pH higher.

 

[soccerballbmw]

Back up in the menu and select Schedule. First one should be Pool. Change to 8 am to 8 am.

Continuously running a fountain will tend to push pH higher.

Thanks! I know how to change the schedule in it self, but not sure how to assign X time to various Speeds.

I've just been adding muriatic acid when the PH gets too high, which to your point is fairly constant, but unless continuously adding the acid is harmful, it seems worth it.

 

[mknauss]

Speeds are assigned to the Circuit. Under Settings, Intelliflo, you assign rpm to a Circuit. Sounds like you only have Pool.

I am assuming you do not have ScreenLogic. It would make all this much easier.

 

[soccerballbmw]

Unfortunately not. It wasn’t offered as an option with my builder.