Hey everyone... I took some readings.
CH 90
total Alkalinity 80
PH 7.5
CYA 50
Temp 83
When I use the whiz wheel in my kit, it shows me at a -5 saturation index.
I'm trying to decide what to adjust... I am going to bump up my PH a little to 7.7 - 7.8... my ch is low according to the book, but My pool is AquaBrite. is there any point in raising it since AB is basically impervious plastic? at 90 I shouldnt be too worried about corrosion to my heater.
What do you think?
CH 90
total Alkalinity 80
PH 7.5
CYA 50
Temp 83
When I use the whiz wheel in my kit, it shows me at a -5 saturation index.
I'm trying to decide what to adjust... I am going to bump up my PH a little to 7.7 - 7.8... my ch is low according to the book, but My pool is AquaBrite. is there any point in raising it since AB is basically impervious plastic? at 90 I shouldnt be too worried about corrosion to my heater.
What do you think?