Concrete cantilever coping chipping

Apr 27, 2011
26
Myrtle Beach, SC
Any thoughts on what I could do to repair this. I have a few places where the coping is starting to break off. Our pool was installed in 2020 and is fiberglass. I realize that he probably should have had the plumb strip put in. I am also worried about that corner where the control joints are -- its even higher where it could break off.

Thanks,
Mark

1.jpg2.jpg
 
I'd give it some time to break off wherever it's going to, then run a line of tape above and below the area and caulk it.
 
  • Like
Reactions: kimkats
Where are you located?

Please put your location in your Profile so it show..
<<<-------- here

Knowing your location can affect our recommendations for you.
 
Thanks, just did -- Myrtle Beach
I was wondering if you were in a snow and freeze/thaw area. Water getting into those cracks and freezing will eventually crack it off.

I would take some tan colored grout and fill in the cracks. It may save it for a few years.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.