I have replace a burned up cell and power cord.
Last fall before closing the pool for the fall my SWG cell and power cord melted.
I replaced the cell with a genuine replacement cpsc16 and a genuine power cord.
Initially I was getting no water fault that I was finally able to eliminate by resoldering the power cord to the PCB.
The system was operating with no issue for two days but now showing non genuine contact dealer error code.
I cannot get past this code, when I power the pool equipment up (after turning the main panel off) the unit displays the ultrakleen but then immediately shows non genuine contact dealer error.
I cannot by pass this by holing down any combination of buttons.
PLEASE help, every forum I find never provides the fix or even a potential fix.
There is a SW1 button on the PCB that I do not know what it is for.
Does anyone have a complete schematic and or service document for the CPSC systems?
Last fall before closing the pool for the fall my SWG cell and power cord melted.
I replaced the cell with a genuine replacement cpsc16 and a genuine power cord.
Initially I was getting no water fault that I was finally able to eliminate by resoldering the power cord to the PCB.
The system was operating with no issue for two days but now showing non genuine contact dealer error code.
I cannot get past this code, when I power the pool equipment up (after turning the main panel off) the unit displays the ultrakleen but then immediately shows non genuine contact dealer error.
I cannot by pass this by holing down any combination of buttons.
PLEASE help, every forum I find never provides the fix or even a potential fix.
There is a SW1 button on the PCB that I do not know what it is for.
Does anyone have a complete schematic and or service document for the CPSC systems?