COMM conflict between Intelliflo VS Pump and Screenlogic2

Jump to latest Follow Reply
The Pentair multiplex board is nothing more then a connection panel that maintains the proper balance for RS-485 when splicing and interconnecting cables.
 
  • Like
Reactions: MyAZPool
Hey just saw the thread... glad you got it sorted.

Those serial expansion boards are a rip off! A few of use have boot-legged our own, mine cost about $4...

IMG_20181023_135314315.jpg
 
  • Like
Reactions: MyAZPool
Hey Allen, sorry for the delay...

The board is a "veroboard" strip board... I'm pretty sure I got mine from Futurlec (years ago!), but they've still got them

Stripboard - Small

Small Stripboard for Building and Testing Electronic Circuits
www.futurlec.com

The terminal blocks are Riacon Metz Connect 4-position, 5mm spacing

The terminal block strips to are Wieland-Electric Z5.530.3425.0

Mouser and Digikey should have the parts as well. I've also got a standard 4-position, 0.1" spacing header at the end, and a 2-pos Metz Connect part (I don't use these often).

Here's the back... stupid simple to solder up with as many extra ports as you like. The screw posts were from my junk bin.

IMG_20181023_135326156.jpg
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply