Pump is new single speed, there are two inlets (one for deep end skimmer+main drain; the other one from shallow end skimmer) going into the inlet pipe into the pump. The valve on inlet pipe going to pump only has three positions to either let one inlet from skimmers through or both inlets.
My equipment pad is actually a little below the pool water level. I read the Jandy manual about the cleaning basket says "close the isolation valves on the suction, and discharging side of the pump to prevent water backflow" if the pump is lower than water level. What are those valves in my case?
I just twisted open the lid and water is pouring out, so I put the lid back on immediately and locked it by hand while water is pouring and pushing the pump lid. I have power outage right now so cannot test the pump priming. Is there anything I should do when the power is back on?
Thanks a lot.
My equipment pad is actually a little below the pool water level. I read the Jandy manual about the cleaning basket says "close the isolation valves on the suction, and discharging side of the pump to prevent water backflow" if the pump is lower than water level. What are those valves in my case?
I just twisted open the lid and water is pouring out, so I put the lid back on immediately and locked it by hand while water is pouring and pushing the pump lid. I have power outage right now so cannot test the pump priming. Is there anything I should do when the power is back on?
Thanks a lot.
Last edited: