I recently bought and installed a brand new cirupool t15 salt cell this weekend, it replaced a hayward turbo t15 cell, the control module is an aquarite goldline model # is AQR15 I have a 27k gallon vinyl inground pool with a cartridge filtration system. The control module is about 8 years old. The display seems to be working fine, i have tried re calibrating the control module, and the issue is the check salt and inspect cell light comes on after the system has been generating for about two minutes. (for some reason when the control switch is in the auto position and I press the diagnostic button nothing happens.) i have seen multiple youtube videos on recalibration, i even tried calling hayward tech support which was a joke. I tried following instructions from the hayward manual on their website. still I haven't been able to get an accurate salt reading. the software is up to date, the amps are in range. yes the control module is set on the correct cell size, the salt was professionally tested today and is in the range of 3600-3700ppm the pool temp is at 75. please any info on how i can get my salt system running accurately again would be greatly appreciated.
Last edited:
Perhaps the following can help?? Do you test the salt with a salt test such as the K-1766 by Taylor?? You need to always trust it before you trust the device.
