- Jun 28, 2016
- 44
- Pool Size
- 22000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool SJ-40
So I installed this system 3 years ago. I had the si-40 cell and it started showing check cell and then it wouldn’t generate any chlorine. I purchased a Si-45 cell which Circupool told me was the direct replacement for the discontinued si-40. I installed it and it’s ram great for 3 days. Now it’s back to same error message of “sLow” The average salt level on the controller reads 3200, but the instantaneous reading shows 1900. Ph is 7.8. Salt levels were verified as 3200 from a pool company that came out to inspect my old cell and clean it 10 days ago. It was perfectly clean BTW. If I completely reset it(disconnect power by turning off the pump) and then restarting it will work for 5-12 hours and then the same error of sLow and the check salt and check cell led on solid. What should my next steps be?