I replaced the SWG cell on my Edge 25 a few months ago with few issues. Yesterday I noticed the water flow light was on, so I tried increasing pump speed (was already pretty high), resetting everything, reseating cables, and checking for damage. Nothing was resolving the issue. I went out to check it again just now and it is off. Searching the forum, I see people had issues with the control board. Just wanted to check here if there were any tips on the sensor itself while I call up Circupool.
Circupool Edge 25 Water Flow Light
- Thread starter Rodex
- Start date
- Jul 21, 2013
- 65,407
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
When was the last time you backwashed your filter?
What is your filter PSI?
A dirty filter will reduce the flow to where the SWG flow switch may no longer engage.
What is your filter PSI?
A dirty filter will reduce the flow to where the SWG flow switch may no longer engage.
Backwashed just a few weeks ago, and filter is at 5PSI (same as when I recharge it).
5 psi doesn't tell us anything as it's at a low rpm setting. Bring the rpm up to 3000 and see what the psi is then. Best Would be to know your clean pressure at let's say 3000 rpm so when you need to compare what your pressure is currently you would be able to bring the RPM back to 3000 and see what the PSI reading is but not knowing what clean PSI is you will not really know what the condition of your filters.
