Cannot tighten ring on sta-rite system 2 filter

[Mofonator]

Hi, I just had a 24 ft AGP installed and filled. I went to fill the filter, and it is leaking around the ring. I saw that the installer didn't use the small tube of silicon provided, so I applied it the best I could, but am unable to get the ring around to 'click' through the tab. I tried all evening, but I keep coming about 1/2 inch short. My question is, would getting more silicon and applying it freely help get the filter top to sit properly, or am I missing something else?

Thanks!
Mofonator

 

[zea3]

Hi, welcome to TFP! Make sure the o-ring is not being pinched between the two halves of the filter. Once everything is lined up you may need to push the top of the filter down more firmly so it is well seated, then try to lock the ring in place.

 

[kadavis]

Are you putting lube on o ring only, if so the top half is not pushed down all the way and ring won't engage

 

[Mofonator]

Thanks for the quick replies.

I checked and the o-ring is not being pinched.

yes, I only lubed the ring itself. Should I do the base as well?

One thing I did notice, is that the filter will move a bit even after being put into it's spot. Move may not be the right word. It will tip from front to back. I kind of expected it to be more firmly in place.

 

[zea3]

You should only put lube on the o-ring. It sounds like you may need the installer to take a look at it. Could you post a picture of the filter and how it is set up?

 

[Mofonator]

I am at work now, but will post pictures later. I am waiting for the installer to call me back. I'll keep you posted.

Thanks for the advice!

 

[Mofonator]

I am now up the creek. I have the ring almost closed, but now cannot get it on or off. It wouldn't be so bad if the 4 kids weren't mocking me about it.

Here are couple of pics I just took of the ring. Any insight would be appreciated.

 

[Mofonator]

ok, so with some help from my 10 year old and a rubber mallet, I was able to remove the lid, clean it, and resilicon the o-ring

I was able to put it back all the way. Now it i leaking. The water comes down the tank where the tabs are. (see pic
)

This is where the o-ring is:

I'm wondering if it should be here:

Any Suggestions ?

Mofonator

 

[Mofonator]

So the position of the o-ring was the issue. I moved it to the other groove and it tightened with ease.

Mofonator

 

[zea3]

Great! So no more leaks?