My opinion is that there is no acceptable fix for a cracked filter.
Does anyone have any methods that they think would provide a good fix?
Does anyone have any methods that they think would provide a good fix?
THIS FILTER OPERATES UNDER HIGH PRESSURE
When any part of the circulating system, (e.g., closure, pump, filter, valve(s), etc.), is serviced, air can enter
the system and become pressurized. Pressurized air can cause the top closure to separate which can
result in severe injury, death, or property damage. To avoid this potential hazard, follow these instructions:
This filter must be installed by a qualified pool serviceman in accordance with all applicable local codes
and ordinances. Improper installation could result in death or serious injury to pool users, installers, or
others and may also cause damage to property.
Do not operate the filter until you have read and understand clearly all the operating instructions
and warning messages for all equipment that is a part of the pool circulating system. The following
instructions are intended as a guide for initially operating the filter in a general pool installation. Failure
to follow all operating instructions and warning messages can result in property damage or severe
personal injury or death.
Never exceed the maximum operating pressure of the system components. Exceeding these limits
could result in a component failing under pressure. This instantaneous release of energy can cause the
filter to separate and could cause severe personal injury or death if they were to strike a person.
I say no.
It's a pressure vessel.
I wouldn't trust epoxy and fiberglass wrapped around the outside of a cracked propane tank, either