I've read through a decent number of threads on bubbles in the return jet and see a lot about the supply side.
I've gone through a lot of the common suggestions with no luck:
Cleaning and lubing pump lid oring
Ensured all fittings are on well
Checked the pump drain
Wrapped different connections in plastic wrap to check if bubbles stop
Water level is fine
When I turn off the pump water drains to pool until below the incoming line entrance into the pump.
I did figure out a weird symptom that I dont quite understand what it means so I'm looking for a pointer.
When I do the following the bubbles are gone for a period of time but slowly return over time.
Turn the pump off
Switch the filter to waste
Turn pump on and let it prime and run for a few seconds after full prime
Turn pump off
Switch back to filtering
Turn pump back on
No bubbles! They return of course.
Just not sure what this means. Any ideas
I've gone through a lot of the common suggestions with no luck:
Cleaning and lubing pump lid oring
Ensured all fittings are on well
Checked the pump drain
Wrapped different connections in plastic wrap to check if bubbles stop
Water level is fine
When I turn off the pump water drains to pool until below the incoming line entrance into the pump.
I did figure out a weird symptom that I dont quite understand what it means so I'm looking for a pointer.
When I do the following the bubbles are gone for a period of time but slowly return over time.
Turn the pump off
Switch the filter to waste
Turn pump on and let it prime and run for a few seconds after full prime
Turn pump off
Switch back to filtering
Turn pump back on
No bubbles! They return of course.
Just not sure what this means. Any ideas