Good Day all.
My fiberglass pool has a Brilliant Wonders 1.5 LED light installed that I want to remove for the winter, it is at approximately 30 inches below the water level, so draining down to that level is far from being practical. So my main question is: is there an issue remove it under water? (manufacture says to drain below light level) I should have enough wire to pull it out of the water to disconnect the connector. Second question is regarding the O-Rings, are they under the lens? because according to the O-ring replacement instructions (attached) they are on the back end however pictures on internet don't seem to show the O-rings located there. Finally if those O-rings are really under the lens that that mean that the Niche/pipe that the wire runs through would in fact be full of water at all time?
My fiberglass pool has a Brilliant Wonders 1.5 LED light installed that I want to remove for the winter, it is at approximately 30 inches below the water level, so draining down to that level is far from being practical. So my main question is: is there an issue remove it under water? (manufacture says to drain below light level) I should have enough wire to pull it out of the water to disconnect the connector. Second question is regarding the O-Rings, are they under the lens? because according to the O-ring replacement instructions (attached) they are on the back end however pictures on internet don't seem to show the O-rings located there. Finally if those O-rings are really under the lens that that mean that the Niche/pipe that the wire runs through would in fact be full of water at all time?