Installed brand new replacement Mastertemp 400 but it won't ignite
powered up, pad reads 62* water temp. heat is set to highest at 104* as well on easy touch and phone(automation). removed jumper & installed easy touch leads
as blower winds up, I get service heater light that goes out after what seems blower reaches proper rpm, then blinking heating light for a couple minutes. blower stops, service heater light comes on & stays on.
no codes on pad or board under top panel just the LED11 after blower stops
kill the power, do it all over again 5 or 6 times now. thinking air in gas line
gas is on, all valves on pipes as well as heater switch. I even bled the line up to the heater.
water pressure is good. 3hpVS @ 2200 rpm
is there something I've missed? Sorry for another Mastertemp thread but I could not find anything in the search... this heater is brand new, I do have the old heater available to swap parts if needed.
thank you, very frustrated !
powered up, pad reads 62* water temp. heat is set to highest at 104* as well on easy touch and phone(automation). removed jumper & installed easy touch leads
as blower winds up, I get service heater light that goes out after what seems blower reaches proper rpm, then blinking heating light for a couple minutes. blower stops, service heater light comes on & stays on.
no codes on pad or board under top panel just the LED11 after blower stops
kill the power, do it all over again 5 or 6 times now. thinking air in gas line
gas is on, all valves on pipes as well as heater switch. I even bled the line up to the heater.
water pressure is good. 3hpVS @ 2200 rpm
is there something I've missed? Sorry for another Mastertemp thread but I could not find anything in the search... this heater is brand new, I do have the old heater available to swap parts if needed.
thank you, very frustrated !