Blueworks BLSC 40 low salt error possible fix.

[Hal3]

I cleaned my salt cell yesterday and all seemed well. This morning my "Low Salt" and "Check Cell" lights were back on. After searching on YouTube I found a possible fix for a different Blueworks model with switches and a knob but I didn't see anything for this model.

My chlorinator was displaying 0000 salt even though I know that was wrong. I fiddled around with the "buttons" for a while. I think this fixed it. (Adapted from the switch and knob model.)

1. Turn off the chlorinator until the display powers down.

2. Turn on the chlorinator.

3. Press Menu until the salt level is displayed. Mine was 0000.

4. Press the salinity "button" five times.

My salt level immediately read 2500 and the "Low Salt" and "Check Cell" lights went out.

Fingers crossed!

 

[YippeeSkippy]

Fingers crossed you found the solution!

 

[Hal3]

So far, so good!

Maybe this is in the manual (couldn't find) and a dozen other places but I didn't find it anywhere. Hope it continues to work and maybe help someone else.

 

[Hal3]

Still working!