- Jul 21, 2013
- 65,077
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Before I consider installing a SWG, few qualifying questions plz
- Thread starter tstex
- Start date
Perfect, thanks. Under the panel and that means I only need to get just the cell and flow monitor and not the whole AquaRite panel.
Thanks again!
Thanks again!
- Jul 21, 2013
- 65,077
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
OK, so I get the Hayward AquaRite T-cell 15 for 40K pool, a flow switch and 2 2" unions.
Once I achieve 3000PPM salt in pool, fire-up the T-cell. Cell should be placed after the heater and close to the pool/spa return pipes. What is "normal" level of FC production[4 or 5 FC target] right out of the T-Cell? Can the T-cell be placed b4 the heater and or filter?
Flow switch measures the FC Output and where is the most optimal placement? One all is installed, then go to panel to set-up Salt cell to specified levels of output and low & hi threshold settings...
Am I missing anything ?
Thank you
Once I achieve 3000PPM salt in pool, fire-up the T-cell. Cell should be placed after the heater and close to the pool/spa return pipes. What is "normal" level of FC production[4 or 5 FC target] right out of the T-Cell? Can the T-cell be placed b4 the heater and or filter?
Flow switch measures the FC Output and where is the most optimal placement? One all is installed, then go to panel to set-up Salt cell to specified levels of output and low & hi threshold settings...
Am I missing anything ?
Thank you
- Jul 21, 2013
- 65,077
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Have you reviewed pages 11-12 of the ProLogic manual?
https://hayward-pool-assets.com/ass...-PL-PS-x&PL-PS-x-VInstallationOct08&Later.pdf
https://hayward-pool-assets.com/ass...-PL-PS-x&PL-PS-x-VInstallationOct08&Later.pdf
just read 11-12...got it...flow switch needs 12" pipe or the body of T-cell before the flow switcvh to insure it can measure full water flow.
Has to be installed after heater and filter* and before returns to spa & pool...I'm running tight there so I might be improvising some vertical installs. Should have intuitively knew that it couldn't be installed b4 filter bc any debris getting stuck would not be good.
Will do a drawings and materials list...once verified, order is going to hit the i-net..
Thank you Allen from the Garden State
Has to be installed after heater and filter* and before returns to spa & pool...I'm running tight there so I might be improvising some vertical installs. Should have intuitively knew that it couldn't be installed b4 filter bc any debris getting stuck would not be good.
Will do a drawings and materials list...once verified, order is going to hit the i-net..
Thank you Allen from the Garden State
Last edited:
Was doing some searches on TFP w new SWG installs and read that a SWG does not product CL when temp is 60 degrees or less. In Tx, we have times where 60 degree temps and getting lower in the future is optimal SPA and Swedish Cold Plunges...what do you do for CL when it's colder ?