Last year we had our pool replastered with diamond brite. It came out very streaky and blotchy and we were not happy with the results. The GC ended up giving the pool 3 acid baths to try to even out the color. They also closed the pool at the end of the season after the last acid bath. I just opened the pool and there are black streaks down the sides all around the pool. The shock and brushing do not remove These stains. I need advice on how to proceed. Is this due to the acid baths or a bad plaster job?
Bad Plaster Job
- Thread starter Brendaneg
- Start date
- Jul 21, 2013
- 53,048
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
Go though the stain identification process described below and see if anything makes a difference...
www.troublefreepool.com
Go though the stain identification process described below and see if anything makes a difference...
Stains in Your Pool
The stained pool is beyond embarrassing. Our in-depth Guide to remove stains in your pool will help you to remove the stains and prevent them in the future.
www.troublefreepool.com
Welcome to TFP.
Go though the stain identification process described below and see if anything makes a difference...
Stains in Your Pool
The stained pool is beyond embarrassing. Our in-depth Guide to remove stains in your pool will help you to remove the stains and prevent them in the future.
Thanks I’ll give it a try.
