I just cleaned the cell, tried to replace it with my old cell and even bought a new cable to connect the cell. Still after turning it on, a few minutes later I either get a low amps or a check/clean cell error.
When I check the voltage/current it is always reading 32V and between 2.1/3.5A. Setting is level 1 (couldn’t figure out how to change)
Any ideas what the issue could be? Could be two bad cells I suppose.
When I check the voltage/current it is always reading 32V and between 2.1/3.5A. Setting is level 1 (couldn’t figure out how to change)
Any ideas what the issue could be? Could be two bad cells I suppose.
