I have an Aquarite salt system. My display reads 9900 all the time. I’ve checked the board for apparent loose connections, found none. Any help ? It’s a 1.59 board.
Yesterday "inspect Cell" was on, while i was turning the system off i noticed that the display would flash and "jiggle" a little when i moved the switch or pressed the diagnostic button, seemed like a loose or dirty connection. I took the cell off and started a cleaning in a bucket with diluted...
How do I get the PCB to go into diagnostic mode? I can only toggle through the general areas on the display board. I've gotten to the AL-5 and tried moving the switch from auto to super and back several times but nothing happens.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!