I have an automated Auqalink RS8 to control one pump with two actuators for pool and SPA. It works fine for years, but it suddenly stopped working for spa mode. The actuator for pool/spa inlet stopped working. The other one for return works fine.
After testing for a while, the problem was rooted to the RS8 system. The two actuators are connected to the RS board separately with 3 line connector. White/Red/Black. The white/black is 24 volts, but the red/black is only 12 volts for the stop-working actuator.
I bet it is not connecting loose problem. Any suggestions for the next step?
Thanks.
After testing for a while, the problem was rooted to the RS8 system. The two actuators are connected to the RS board separately with 3 line connector. White/Red/Black. The white/black is 24 volts, but the red/black is only 12 volts for the stop-working actuator.
I bet it is not connecting loose problem. Any suggestions for the next step?
Thanks.