I just bought a house and from what I can tell the aqualink is old, it’s an RS4. Id like to be able to get it to the aquiline 3.0, but not sure what path I need to get there. Opened up the controller and got some photos of the board. Any advice is appreciated.
Aqualink advice, upgrade path
- Thread starter Brembold
- Start date
- Jul 21, 2013
- 54,775
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
You can upgrade it to iAqualink IQ30-RS if you want to stay in the Jandy ecosystem or do like I did and replace it with a Pentair IntelliCenter.
www.troublefreepool.com
www.troublefreepool.com
Jandy Aqualink RS - Further Reading
www.troublefreepool.com
Replacing an Aqualink with an IntelliCenter
This thread is for me to work out what I do in upgrading my 20 year old pool equipment. Jandy RS8 automation, 1.5HP SS Pentair pump, Pentair Mastertemp 400 NG heater, IC40 SWG, typical pool/spa combo with spa spillover, Pentair JVA actuators on suctions & return Jandy valves, 1HP pump for spa...
www.troublefreepool.com
I’ve never do a replacement, pretty easy to wire up and configure?You can upgrade it to iAqualink IQ30-RS if you want to stay in the Jandy ecosystem or do like I did and replace it with a Pentair IntelliCenter.
Jandy Aqualink RS - Further Reading
Replacing an Aqualink with an IntelliCenter
This thread is for me to work out what I do in upgrading my 20 year old pool equipment. Jandy RS8 automation, 1.5HP SS Pentair pump, Pentair Mastertemp 400 NG heater, IC40 SWG, typical pool/spa combo with spa spillover, Pentair JVA actuators on suctions & return Jandy valves, 1HP pump for spa...
- Jul 21, 2013
- 54,775
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
If you can do basic electrical wiring and follow the Installation Manual.
Download the Installation Manual and review it.
When you are done you will understand your pool equipment.