I'll preface this with it's a silly situation/bug but I've spent a few hours trying to track down why this seems to just now be happening and any insight would be greatly appreciated.
Typically the unit would revert to the standard salt display when you're done cycling through the menu after about 30 seconds, but in the past week I noticed that instead of reverting back to that display it goes to the "Desired output %" display instead. It was installed in 2006, and I just replaced the main PCB board about 15 months ago. I've done a hard reset, unplugged the cell and done just about everything else I could think of and it keeps going back to the "10P" display for my run percentage. It's running fine, generating chlorine, and otherwise has no issues but it just seems weird that it just now started doing this, so if anyone knows why, or how I can get it to go back to reverting to the standard salt display that'd be great.
If this has already been asked and solved I do apologize I tried to search for it but came up empty.
Typically the unit would revert to the standard salt display when you're done cycling through the menu after about 30 seconds, but in the past week I noticed that instead of reverting back to that display it goes to the "Desired output %" display instead. It was installed in 2006, and I just replaced the main PCB board about 15 months ago. I've done a hard reset, unplugged the cell and done just about everything else I could think of and it keeps going back to the "10P" display for my run percentage. It's running fine, generating chlorine, and otherwise has no issues but it just seems weird that it just now started doing this, so if anyone knows why, or how I can get it to go back to reverting to the standard salt display that'd be great.
If this has already been asked and solved I do apologize I tried to search for it but came up empty.