So i have had the pool open for a couple weeks now and have gotten all the chemicals right and temp above 70, but the SWG is giving me these errors (low salt and High cell current and cell voltage below 19v. The back board was replaced by me two summers ago and has been working fine. As for the salt issue the board reads zero salt and there is 400 lbs in the pool that I put in the other day. Any help would be great. I have a back board on order, but if this is something easily fixable I would rather do that
Aqua pure 1400 error codes 175/192...help
- Thread starter Chrispatterson99
- Start date
- May 3, 2014
- 58,576
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
How old is the unit?
How old is the cell?
The unit is approximately 10 years old the cell was replaced last year. I have been in this house for three summers now
I had a problem two summers ago with a back board voltage issue. There was a fried connection. Replaced the back board and it worked perfectly. Now I am getting this issue
The unit is seeing flow so there is no air lock situation, and it’s not reading any salt. Doesn’t even say 00 it is just - -
I had a problem two summers ago with a back board voltage issue. There was a fried connection. Replaced the back board and it worked perfectly. Now I am getting this issue
The unit is seeing flow so there is no air lock situation, and it’s not reading any salt. Doesn’t even say 00 it is just - -
Try the troubleshooting guide in the above link.
At 10 years old, you might be better off replacing the unit vs spending hundreds on repairs.
At 10 years old, you might be better off replacing the unit vs spending hundreds on repairs.
What unit would you recommend. I just put a new back board on and it still has the same error. I also noticed that when trying to test the cell voltage it read zero. Could that just be because the cell is not reading any salt?
Do you have a picture of the cell label?
Did you replace the trisensor when you replaced the cell?
Did you replace the trisensor when you replaced the cell?
You got a "Warranty" replacement cell, which doesn't come with a warranty or a trisensor.
A better choice would have been a PLC1400 Cell kit.
In any case, you might want to get a new Aquapure power supply since you have a new cell.
A better choice would have been a PLC1400 Cell kit.
In any case, you might want to get a new Aquapure power supply since you have a new cell.
Well it was free(ish) with my home warranty. But I did replace the dc cable at the same time. Where is the power supply?
It's the box with the controls.
New model is APUREM.
You should replace the trisensor as well.
New model is APUREM.
You should replace the trisensor as well.