Hi all,
I replaced my Aqua Logic main board recently and carefully programmed it the way the old one was setup. Everything works great except when switching it to "spa mode", the actuators do not respond.
Each one is getting power and they rotate the proper way when flipping the micro switch in either direction. Did I miss something in the setup of the new board or could it be the new board is faulty? I've read through the manual but can't seem to find anything different to try.
Thanks in advance for any suggestions!
Tom
I replaced my Aqua Logic main board recently and carefully programmed it the way the old one was setup. Everything works great except when switching it to "spa mode", the actuators do not respond.
Each one is getting power and they rotate the proper way when flipping the micro switch in either direction. Did I miss something in the setup of the new board or could it be the new board is faulty? I've read through the manual but can't seem to find anything different to try.
Thanks in advance for any suggestions!
Tom