I can't figure out how to assign a second VS pump to one of the Aux pump outputs in iAqualink. I have one intelliflo (address 1) set to filter pump, which works and is linked to the filter pump button. I have a second intelliflo connected (address 4) that I can assign to the filter pump as well and will work when filter pump is pressed, but I can't figure out how to assign it to one of the other pump outputs. If I select "Aux Pump" in the setting I can't figure out how to link it with any Aux output.
Adding VS pump to Aux 1/2/3 in iAqualink
- Thread starter Srlake
- Start date
- Jul 21, 2013
- 65,118
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I can go to VSP Pump 4 and adjust the speed and it will control the pump, so it communicates fine. I just can't figure out how to link that to a labelled pump output (e.g the button for Aux 3 on the control panel, which was the pond pump before I switched to a VS pump.
- Jul 21, 2013
- 65,118
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I don't think you can associate VS pump control with an AUX other then the filter/pump AUX.
Is there a way to name these pumps something intelligible then? If you have four VS pumps for example, how would you differentiate them all on the user interface? And there is no way to turn these on/off from the panel in service mode then?
- Jul 21, 2013
- 65,118
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
- Jun 7, 2017
- 9,967
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Update - I figured out how to link a VS pump to a Aux button / name:
You have to go to the edit speeds screen for the pump, then pick one speed you want to be linked to the Aux output, then assign that speed to an Aux output. That output will then show as “on” when the pump is on, and selecting that button will turn the pump on to that speed.
You have to go to the edit speeds screen for the pump, then pick one speed you want to be linked to the Aux output, then assign that speed to an Aux output. That output will then show as “on” when the pump is on, and selecting that button will turn the pump on to that speed.
Attachments
- Jul 21, 2013
- 65,118
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Thanks for the update. I added it to the Wiki.
Jandy Aqualink RS - Further Reading
www.troublefreepool.com
