I am planning to add pool solar soon. I already purchased the rooftop panels and plumbing/connectors/check valves to make all the plumbing connections. But I need to figure out the auto valve actuator and temp sensors before I start cutting into the plumbing. I have a Pentair Intellitouch i7 +3 system with a propane heater. Is it just as simple as buying a Pentair CVA24T valve actuator and plugging it into a pre-readied spot behind the front cover panel (I haven’t had time to go take the panel cover off yet)? Do I need a second air sensor that goes up on the roof near the solar panels, and if so is there also a pre-readied receptacle in the panel for it?