Adding IC60 to EasyTouch 8

[10056753]

I am new to posting on TFP, but been reading a lot. We are in the "hookup electrical" stage of our mechanical room and I am considering adding an IC60. However, since I did not spec it to begin with my PB installed the ET8 without the Intellichlor transformer (see attached image).

My question is, can I just buy a replacement transformer 520722, like this one, connect it to the Intelliflo pump breaker and avoid purchasing the Power Center and avoid installing/wiring an extra device on the wall?

Thanks for any help.

 

[mknauss]

Welcome to the forum.
You will need the surge card also.

 

[Jimrahbe]

###,

You would need the following..

SWCG transformer
Surge card (Power supply card)
Fuse assy and wiring
Cable from Surge card to to connector at bottom of the cabinet where the cell would connect.
RS-485 Cable from the main card to the surge card.

It is cheaper to just buy the external Power Center.

Thanks,

Jim R.

 

[10056753]

Excellent. Thank you so much for the quick response!