Adding Fill Valve to Intellicenter

Jump to latest Follow Reply
You should report your findings back to the equipment installer and let them know that the relay board on the IntelliCenter is not designed to drive external valves that require more current than the driver chip can provide. What was possible with the older EasyTouch panels is not possible with the latest technology. Otherwise they are going to keep blowing out customers circuit boards and Pentair will most-assuredly NOT cover the damage under any warranty as it’s an obvious violation of the proper setup of the IntelliCenter.
 
  • Like
Reactions: Flying Tivo
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply