Accessing Pump Speed on an EasyTouch Panel

Kit · May 26, 2023

My iS4 spaside control has been functioning erratically lately. At times none of the 4 buttons work. Until I eventually replace the unit, I want to be able to change the pump speed from 1,700 rpms (for general filtration & chlorine production) to 2,500 rpms whenever I use the spa. Generally I would use the spaside to do so. My question: how can I increase the pump speed on the EasyTouch panel? Thank you so much for your help!

Kit

mknauss · May 26, 2023

You use the Valves button (V) to change to Spa on the panel.

mknauss · May 26, 2023

You will likely find it is same cost or cheaper to get a Screenlogic for your Easytouch vs replacing the spa side. Or upgrade to Intellicenter.

Kit · May 26, 2023

Thank you for the quick response. If I press the V button to switch to the Spa mode, I will also activate the heater if the set temperature of the spa is higher than the current water temperature. Is there a quick way to increase the pump speed only? Thanks!

I will look into a Screenlogic or Intellicenter as options.

mknauss · May 26, 2023

You need to go into the set up screen and increase the pump speed. If you have an open Aux you can set up a circuit tied to it with the higher rpm.

Jimrahbe · May 26, 2023

Kit,

Just set your Spa Circuit to 1700 RPM.

Menu, Settings, IntelliFlo, Pump #1, Speeds, scroll to find the Spa Circuit, change the speed to 1700.

Anytime you go into the spa mode the pump will run at 1700 RPM.

Thanks,

Jim R.

Kit · May 26, 2023

mknauss said:
You need to go into the set up screen and increase the pump speed. If you have an open Aux you can set up a circuit tied to it with the higher rpm.

Thanks, Marty.

Kit · May 26, 2023

Jimrahbe said:
Kit,

Just set your Spa Circuit to 1700 RPM.

Menu, Settings, IntelliFlo, Pump #1, Speeds, scroll to find the Spa Circuit, change the speed to 1700.

Anytime you go into the spa mode the pump will run at 1700 RPM.

Thanks,

Jim R.

Thanks, Jim. That makes perfect sense. However, the reality is that I will likely have to replace the SpaSide or maybe install a Screenlogic instead as Marty suggested. I posted a few questions I had on another thread. Again...thank you.