In taking day time readings that require a chlorine addition, how long after adding can I get an accurate reading? Next, I read on a past post that after having the initial ph level at 7.2, any future readings will not be accurate so no need to do them. Is this right?
A couple SLAM questions
- Thread starter szap
- Start date
- May 3, 2014
- 62,702
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Once you start the SLAM Process, you test only FC until the end.
No real need to test FC after adding your chlorine. Just test and add chlorine as needed several times per day.
No real need to test FC after adding your chlorine. Just test and add chlorine as needed several times per day.
- Feb 6, 2015
- 7,813
- Pool Size
- 12300
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
After adding chlorine with the pump running, you can retest in 15-20 minutes.
The pH test is not valid if the FC is greater than 10.
But if in SLAM mode, do as Marty suggests.
The pH test is not valid if the FC is greater than 10.
But if in SLAM mode, do as Marty suggests.