Hi,
When i push the on button the unit makes a clicking noise for about 5 sec and then the display shows error code HF which my manual says is a flame fault failure and to replace the igniter. However, I unscrewed the bracket for igniter and pulled out from under heater. I can clearly see the spark across the electrodes when i push the start button . I verified that gas valve was in open position and also took off the nozzles and cleaned some spider webs out.
Any suggestions on what direction to go now.
Thank you
When i push the on button the unit makes a clicking noise for about 5 sec and then the display shows error code HF which my manual says is a flame fault failure and to replace the igniter. However, I unscrewed the bracket for igniter and pulled out from under heater. I can clearly see the spark across the electrodes when i push the start button . I verified that gas valve was in open position and also took off the nozzles and cleaned some spider webs out.
Any suggestions on what direction to go now.
Thank you