Hello Forum Members,
I've recently run into a problem trying to send communication from
my pentair intellitouch i9 to my Sta Rite Heater.
hopefully i can gain some words of advice from the experts here.
switching between Spa or Pool remotely does not seem to change the Sta Rite Heater's
local spa/pool setting, however the heater is engaged correctly.
example if I send a control command to the heater to engage the spa, it will heat the spa to whatever
the Sta Rite front panel was last selected . (if pool selected it will only heat to the preset pool level)
(if spa is selected locally on front panel then all is good, as the correct high temp setting is read and actioned)
again, the front panel of the Sta Rite seems to not be remotely being controlled by the intellitouch
with regards to recalling the correct spa or pool high temp setting.
there are no warning messages and the system fires/shuts down correctly.
I hope i've made myself clear.
I've checked the 2wire connection between the intellitouch board and the star rite fireman's switch and
i don't see any loose wires.
The system was working correctly a few months ago.
thanks for any suggestions !
kind regards
alex
I've recently run into a problem trying to send communication from
my pentair intellitouch i9 to my Sta Rite Heater.
hopefully i can gain some words of advice from the experts here.
switching between Spa or Pool remotely does not seem to change the Sta Rite Heater's
local spa/pool setting, however the heater is engaged correctly.
example if I send a control command to the heater to engage the spa, it will heat the spa to whatever
the Sta Rite front panel was last selected . (if pool selected it will only heat to the preset pool level)
(if spa is selected locally on front panel then all is good, as the correct high temp setting is read and actioned)
again, the front panel of the Sta Rite seems to not be remotely being controlled by the intellitouch
with regards to recalling the correct spa or pool high temp setting.
there are no warning messages and the system fires/shuts down correctly.
I hope i've made myself clear.
I've checked the 2wire connection between the intellitouch board and the star rite fireman's switch and
i don't see any loose wires.
The system was working correctly a few months ago.
thanks for any suggestions !
kind regards
alex