I hope this is in the correct place . I have an indoor pool I was having foaming issues . Used defoamer ok results for awhile . But soon got out of hand . Did enzyme treatment worked well for a week then back to foam ( not bubbles as much as soap suds )
I'm at my minds end with this ! So I drained 2/3 of pool water about 10,000 gallons re filled added enzyms and even put oil clean up pads in the pool .
Checked pool today and I don't feel like I'm getting anywhere can see what looks like oil on the suface .
Chemicals are always on target . A little off now due to the draining .
Pool is vinyl in ground about 15000 gallon temp is kept at 85 on a liquid feeder
I need to get the oil off the suface . So my new plan is to drain pool a couple inches at a time ( so I'm taking off the surface oils only ) with multi port set to waste . Refill repeat ,repeat ,repeat ......
I know the best option would be to drain the whole pool and start over but due to high water table this is not an option . I'm open to ideas here
I'm at my minds end with this ! So I drained 2/3 of pool water about 10,000 gallons re filled added enzyms and even put oil clean up pads in the pool .
Checked pool today and I don't feel like I'm getting anywhere can see what looks like oil on the suface .
Chemicals are always on target . A little off now due to the draining .
Pool is vinyl in ground about 15000 gallon temp is kept at 85 on a liquid feeder
I need to get the oil off the suface . So my new plan is to drain pool a couple inches at a time ( so I'm taking off the surface oils only ) with multi port set to waste . Refill repeat ,repeat ,repeat ......
I know the best option would be to drain the whole pool and start over but due to high water table this is not an option . I'm open to ideas here