Hello All,
We are nearing the end of our pool building project....and this forum has been unbelieveably helpful. We are having some trouble and I need some help. We have an in ground vinyl pool with an attatched spa. All controls are Goldline. First issue is that when we turn the blower on for more than 20 minutes it overheats and shuts off. I assume it is overheating because after an hour or 2 it will work again for another 20 minutes. The second issue is that the remote shows the error "High Salt/Amps" and shuts the Chlorinator as soon as the spa begins to run (within a minute or so). As soon as you activate the pool again, the error goes away and the chlorinator begins working normally. The remote reads salt between 3300 and 3400 ppm. The pool builder tells me both of these conditions are normal, but I think he's telling me a story. He says the high heat of the spa causes the cell to malfunction...but it happens even when spa water is cool. Any assitance would be greatly appreciated. Thanks.
Rob
We are nearing the end of our pool building project....and this forum has been unbelieveably helpful. We are having some trouble and I need some help. We have an in ground vinyl pool with an attatched spa. All controls are Goldline. First issue is that when we turn the blower on for more than 20 minutes it overheats and shuts off. I assume it is overheating because after an hour or 2 it will work again for another 20 minutes. The second issue is that the remote shows the error "High Salt/Amps" and shuts the Chlorinator as soon as the spa begins to run (within a minute or so). As soon as you activate the pool again, the error goes away and the chlorinator begins working normally. The remote reads salt between 3300 and 3400 ppm. The pool builder tells me both of these conditions are normal, but I think he's telling me a story. He says the high heat of the spa causes the cell to malfunction...but it happens even when spa water is cool. Any assitance would be greatly appreciated. Thanks.
Rob